Before & After Photos

The homeowner call because he had raccoons under his 4 season room that tore all the insulation foam board and fiberglass out. Our solution was to remove the foam board insulation and the fiberglass batt insulation and dispose of it, then we disinfect the area, and install foam board insulation with a radiant barrier on either side and finish it off with Air Sealing all of the gaps.   

 The homeowner explained that she had mold in her attic after an initial home inspection was made for a home sale. The problem was caused by the soffits being blocked and not allowing air to pass through the soffits up to the ridge vent.  

 The homeowner explained that he had a gas heater installed in the garage to prevent the exposed pipes from freezing within the garage.

The homeowner explained that he noticed his Fireplace Den in the house that is also adjacent to the garage was always cold during the winter months and warm during the summer. He also explained that he would like to make improvements with making his home more energy efficient with current tax breaks.

  Our customers home was for sale and a home inspection found mold in the attic. Once our inspection was completed we were able to find why mold became a problem in this attic. The installed batt fiberglass was pressed up to the outer edge not allowing for any airflow to be possible. There were a few baffles improperly installed but clearly not enough to allow proper ventilation for this attic to breathe. Our solution was to treat the mold with Mold X2 products and add new baffles pulling insulation away from edge and clearing the eaves of any debris. Our customers home now has a clean and properly breathing attic for his family now and the new homeowner soon.